Dukane iQ Series User Manual download pdf (Page 34)

Page 28

iQ Series, Ultrasonic Generator/Power Supply LS-E User’s Manual

Dukane Manual Part No. 403-588-00

Figure 4 - 6 DB-25F, Generator Output Connector (J3)

Pin 22 (System Ready Status Output)

This status output signal will activate only when the

system is ready to activate ultrasound or begin a weld

cycle. Pin 22 is a digital status output that activates

when a weld processing cycle is completed and the

welding process control system is ready to start the next

welding cycle. This output will be an open circuit when

the welding process controller determines that the next

welding cycle cannot be started. This includes system

faults or ofine active, but not a process fault like

Overload.

Pin 23 (Suspect Part Status Output)

Pin 23 is a digital status output that activates, either

momentarily or until the start of the next welding cycle,

when the welding parameters recorded during the

previous welding cycle are outside of the programmed

suspect part limits. This output will be an open circuit

after a welding cycle when a suspect part has not been

detected.

Pin 24 (Isolated Common)

Pin 24 is electrically isolated from chassis ground.

Pin 25 (Not Used)

Pin 25 is an open connection.

Figure 4 - 7 DB-25M, Generator Output Cable

Connector

1 3 5 7 9 11 13

15 17 19

21 23 25

13 11 9 7 5 3 1

25 23 21 19 17 15

Continued from Previous Page

Continued

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 143 144

No comments

Dukane iQ Series User Manual Page 34