Dukane iQ Series User Manual download pdf (Page 25)

Page 19

Section 3 – Installation

Dukane Manual Part No. 403-573-02

Pin 1 (Enable Out)

This is a current limited voltage source output intended

to connect to an E-Stop circuit. If an E-Stop circuit is

not used, Pin 1 must be jumpered to Pin 2 for ultrasound

operation to be enabled.

Pin 2 (Enable In)

The output from the E-Stop circuit is connected to this

pin when an E-Stop circuit is used. Otherwise, this pin

must be jumpered to Pin 1 for ultrasound operation to

be enabled. See Figure 6-4 for E-Stop circuit wiring

examples.

Pin 3 (Overload Out)

Pin 3 is a non-isolated digital NPN status output that

activates when an output overload condition is tripped.

This output will be an open circuit if an output overload

condition is not tripped. This output will remain latched

ON until the U/S Activate input is switched OFF and

then ON again.

Pin 4 (Ultrasound Active Status Output)

Pin 4 is a non-isolated digital NPN status output that

activates when the system is delivering ultrasonic power

to the load attached to the ultrasound output connector.

This output will be an open circuit when the ultrasound

output is off.

Pin 5 (Any Fault Out)

Pin 5 is a non-isolated digital NPN status output that

activates whenever any fault condition is detected that

inhibits ultrasound output and normal system operation.

This output will be an open circuit when no system fault

conditions are active.

Pin 6 (Power OK Out)

Pin 6 is a non-isolated digital NPN status output that

activates when no fault conditions are detected by any of

the power fault detection circuits included in the system.

This output will be an open circuit when any power

related fault condition is detected.

Pin 7 (Output Common)

Pin 7 is connected to chassis ground. The non-isolated

NPN status output signals can drive isolated PNP inputs

on the automation control system. Refer to Section 6 for

wiring examples to connect output signals.

Pin 8 (Spare Status Out)

Pin 8 is not functional with the standard factory

conguration.

Pin 9 (Analog Power Out +)

Pin 9 is a analog output signal proportional to the true

RMS ultrasound power output level. This signal is

scaled so 1mV = 1 Watt.

Pin 10 (Analog Power Out -)

Pin 10 is a signal ground (non-isolated chassis ground)

for the Analog Power output signal on Pin 9.

Pin 11 (Fault Reset Input)

Pin 11 is an isolated input control signal that will reset

any output faults when it is activated. It can be used

by the automation control system to simplify PLC

programming.

Pin 12 (U/S Activate Input)

Pin 12 is used to activate the generator ultrasound

output. Activating this isolated control input will switch

the ultrasound output ON, and deactivating this signal

will switch ultrasound OFF.

Pin 13 (Input Common)

[Electrically connected to Pin 5 on MPC I/O connector

if MPC Interface option is installed.]

Pin 13 is electrically isolated from chassis ground.

Using sourcing (PNP) output drivers, this common line

would be connected to the automation system power

supply common. Using sinking (NPN) output drivers,

this common line would be connected to the automation

system positive supply

output. Refer to Section 6 for

wiring examples to connect these input signals.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 57 58

Comments to this Manuals

No comments

Dukane iQ Series User Manual Page 25

Comments to this Manuals

Related products and manuals for Power supply units Dukane iQ Series